Screen Print World Blue Blockout Filler for Plastisol

SKU:
RYONETBLOCKOUTFILLER
£8.99 - £29.93 + VAT
(No reviews yet) Write a Review
Current Stock:

Description

This block out filler is for repairing holes or unstable emulsion in screens. This blockout was built to withstand squeegee abrasion and long print runs. Suitable for printing plastisol.

 

Application

  1. When the screen is dry and free of contaminants, pour the Screen Blockout filler on the print side of the screen. Spread over the open areas of the screen until completely filled.
  2. Touch up all defects, including heavy blobs which tend to dry the outside and pop off or smear during printing. Where very fine meshes are used, you may reduce the viscosity by adding a little water.
  3. Remove blockout with water.

For smaller pin holes use the blockout pen.

 

More information.

If you would like more information then please give us a call on 0044 (0) 1562 829009 or use our Webchat or Email

additional_info:
Rack 11
vcwccr_availability_operator:
1
vcwccr_selected_countries:
a:0:{}